The New 3D Printing Thread

There isn't a post, but there is a flat part that it screws through to hold it in place, so that is all sorted.  Height may be an issue, I'll probably get my beta-tester (aka ChrisJo) to test it for me fully once I have a final version printed to send to him.  Although if I squashed it any flatter it would look a bit odd I think, so I'm not sure how I would get round that

The next model I'm working on may prove of interest when its finished.  I've got the first prototype modelled, I'm just waiting for one of the printers to finish printing the finals of this current design before I can run a first prototype out - watch this space