To answer your questions:
Printer: Creality Ender 3 Pro
Slicer: Cura (unsure which version)
Filament: I only have one filament at the moment, I'm planning on getting another filament which hopefully should work better in future.
Settings: Not really, I just used some line supports and that was it.
I'm planning on printing out six of these mail vans and cutting out twelve rods for each of the wheels on them. I wanted versions of the vans similar to the ones that came with the TnA Percy and More Talkative Edward.
And thank you! It wasn't too hard to design since I've had experience, but it was mildly difficult to get the screw-hole right. In fact I'm still struggling to keep it from breaking off but that aside post vans have worked, bear is being mildly problematic.
Printer: Creality Ender 3 Pro
Slicer: Cura (unsure which version)
Filament: I only have one filament at the moment, I'm planning on getting another filament which hopefully should work better in future.
Settings: Not really, I just used some line supports and that was it.
I'm planning on printing out six of these mail vans and cutting out twelve rods for each of the wheels on them. I wanted versions of the vans similar to the ones that came with the TnA Percy and More Talkative Edward.
And thank you! It wasn't too hard to design since I've had experience, but it was mildly difficult to get the screw-hole right. In fact I'm still struggling to keep it from breaking off but that aside post vans have worked, bear is being mildly problematic.
- roxaclock
"see ya around!"
"see ya around!"