Hi OTR ![[Image: salute-smiley-emoticon.gif]](http://www.sherv.net/cm/emoticons/hello/salute-smiley-emoticon.gif)
Yest that is a lovely bridge, too bad that its not an exact match for modern rails as its it tad too short to use with the newer yellow risers. One would have to use the original yellow risers that snap on the tracks for the proper height. Common with trying to blend old with the new. This was even true with the motorized road pieces which I never knew until I acquired the very rare sloped road rails that need no risers.
BTW, Nigels has successfully 3D printed these old viaduct bridges in the proper height and so they don't need any risers on either side.
Yest that is a lovely bridge, too bad that its not an exact match for modern rails as its it tad too short to use with the newer yellow risers. One would have to use the original yellow risers that snap on the tracks for the proper height. Common with trying to blend old with the new. This was even true with the motorized road pieces which I never knew until I acquired the very rare sloped road rails that need no risers.
BTW, Nigels has successfully 3D printed these old viaduct bridges in the proper height and so they don't need any risers on either side.
![[Image: super-smiley-emoticon.gif]](http://www.sherv.net/cm/emo/word/super-smiley-emoticon.gif)